---
title: Activate the AI Edge Gateway
description: "### AI Edge Gateway (indoor version) The…"
url: "https://manual.amnimo.com/docs/ai-edge-gateway-deployment-and-operation-ax-individual-guide-en/activate-the-ai-edge-gateway/"
updated: "2025-02-06"
category: AX個別 / AI エッジゲートウェイの導入と運用（AX個別ガイド）
---

# Activate the AI Edge Gateway

### AI Edge Gateway (indoor version)

The AI Edge Gateway (indoor version) starts automatically when the power supply is connected.

### AI Edge Gateway (outdoor version)

The AI Edge Gateway (outdoor version) is activated when the power supply is connected and the power switch is turned ON.

#### power switch

![](https://manual.amnimo.com/wp-content/uploads/2024/08/AXUM0503-01-1024x561.png)

### DIP switch settings (Linux boot mode)

Set the DIP switch to "Linux boot mode" and connect the power supply as shown below.

![](https://manual.amnimo.com/wp-content/uploads/2024/08/image-73.png)

 **ALERT**

Do not perform the following operations during the startup sequence to avoid malfunction.

- Power ON/OFF
- Removing and inserting SD cards and other storage media
- Switching DIP switches

The status of the AI Edge Gateway can be checked via LEDs on the main unit and the CONSOLE port.

[⇒LED](https://manual.amnimo.com/?post_type=docs&p=12425#led)
⇒CONSOLE [port](https://manual.amnimo.com/?post_type=docs&p=12425#console%E3%83%9D%E3%83%BC%E3%83%88)

 **ALERT**

###### About the initial password for the bootloader

Please contact our customer support for the initial password when starting AI Edge Gateway in U-Boot mode.

　　Contact : Amnimo Customer Support
E-mail : support@amnimo.com
URL : https://support.amnimo.com

Be sure to change this password.