---
title: Activate the device
description: Activate the target device from the Devi…
url: "https://manual.amnimo.com/docs/configure-device-management-system-settings/enable-edge-gateway-2/"
updated: "2025-12-03"
category: "AX-SG / Configure device management system settings"
---

# Activate the device

Activate the target device from the Device Management System.

 **NOTE**

- In order to proceed with activation, it is necessary to complete the time setting on the device in advance.
  ⇒See " [Setting the Time" in the "Setting the Time" section](/?doc_category=時刻を設定する-3).

   

 **WARNING**

Please make sure that the device is connected to the Internet before performing this operation.

Activation usually takes about 10 minutes, but may take up to an hour. If activation is not completed after several tens of minutes, it can be shortened by rebooting the equipment.

  Log in to the [Service Management Portal](https://apps.amnimo.com) with a web browser. On the Dashboard, click Device Management System.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-164.png)

  On the Dashboard screen, click "Device List" to go to the Device List screen.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-165.png)

  Confirm that the status of the target device is "Preparing" (①) and click the \[︙\] button (②).

![](https://manual.amnimo.com/wp-content/uploads/2025/05/ARSG1102-03-1024x567.png)

  ［Click Enable.

![](https://manual.amnimo.com/wp-content/uploads/2025/05/ARSG1102-04-1024x567.png)

  Click Confirm.

![](https://manual.amnimo.com/wp-content/uploads/2025/05/ARSG1102-05.png)

Activation is complete when the device connects to the Internet.

  Verify that the device is in "good" condition and has a good signal.

![](https://manual.amnimo.com/wp-content/uploads/2025/05/ARSG1102-06.png)

    **WARNING**

When a configuration file is initialized from the CLI or GUI for a device already connected to the Device Management System, a communication error continues in the Device Management System even if Internet communication is restored after a reboot. In this case, please deactivate the device in the Device Management System and then re-activate it.