---
title: "Operating the camera's power supply (PoE)"
description: From the gateway configuration, power op…
url: "https://manual.amnimo.com/docs/configure-device-settings-en/operating-the-cameras-power-supply-poe-2/"
updated: "2024-07-23"
category: CVR / Configure device settings
---

# Operating the camera's power supply (PoE)

From the gateway configuration, power operation (PoE) can be performed on the camera.

![](https://amnimo.com/manual/edge_gw/CloudVR/ja/assets/images/image285.png)
**Camera Power Operation (PoE) screen**

- [**① ポート**](#uagb-tabs__tab0)
- [**② リンク状態**](#uagb-tabs__tab1)
- [**③ 給電状態**](#uagb-tabs__tab2)
- [**④ カメラ名 **](#uagb-tabs__tab3)
- [**⑤ アクション**](#uagb-tabs__tab4)

Indicates the name of each port of the device.

Indicates the status of each port.

Up : Link is up.
 Down : Link is down
 Unknown ：State cannot be obtained

Indicates whether power is being supplied.

ON : Power is supplied.
 OFF : Power is not supplied.
 Unknown : When the status cannot be obtained

You can enter a description of the device connected to each port.

You can stop and start the power supply for each port.

Reset : After power supply is stopped, power supply is resumed after a specified time.
 ON : Starts supplying power
 OFF ：Stops power supply

## **PoE power supply reset/ON/OFF procedure**

1. Click ▼ and select Devices.
   ![](https://amnimo.com/manual/edge_gw/CloudVR/ja/assets/images/image37.png)
2. Click on ![](https://amnimo.com/manual/edge_gw/CloudVR/ja/assets/images/image179.png) for the device you wish to reboot, then click on Gateway Settings.
   ![](https://amnimo.com/manual/edge_gw/CloudVR/ja/assets/images/image25.png)
3. Click the button you wish to implement for the target port.
   It is also possible to perform an action on another port while the power supply function of the other port is being reset/turned on/off.
   ![](https://amnimo.com/manual/edge_gw/CloudVR/ja/assets/images/image286.png)
   **Reset (\*)**: Disables the power feed function for a specified time (reset time) and automatically enables it after the specified time elapses.
   **ON**: Enables the power feed function.
   **OFF**: Disables the power feed function.
   The reset time can be set from 1 second to 60 minutes (default setting: 1 minute).
4. When the confirmation screen appears, click \[ Power ON \] or \[ Power OFF \]. For resetting, specify a wait time and click \[ Reset \].
   ![](https://amnimo.com/manual/edge_gw/CloudVR/ja/assets/images/image200.png)