---
title: remote.it
description: This section describes the operation of …
url: "https://manual.amnimo.com/docs/service-configuration-gui/remote-it/"
updated: "2025-11-30"
category: GUI（FW v3.2.0） / サービス設定（GUI）
---

# remote.it

This section describes the operation of the "remote.it" screen.
Here you can configure settings for using remote.it.

Click \[Service Settings\] > \[remote.it\] on the side menu to open the "remote.it Settings" screen.

![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0908-01-1024x411.webp)

## View remote.it settings

The "remote.it settings" screen displays the current status of the remote.it settings.

![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0908-02-1024x357.webp)

## Change remote.it settings

Enables/disables remote.it settings.
Below are the steps for activation.

  Click the toggle.

Enabling "remote.it settings" will allow you to use remote.it to control devices.

![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0908-03-1024x286.webp)

  For Edge Gateway / AI Edge Gateway / IoT Router, click Settings.
For compact routers, perform the following precautionary tasks **NOTE**

For compact routers (amnimo C series), the registration code must be registered.
Registration codes must be obtained separately from the remote.it web page.

Please refer to the following for the setup procedure.
⇒ [amnimo C Series Compact Router Getting Started Guide](https://amnimo.com/manual/edge_gw/sg/ja/compact_router_sg.pdf)

| Edge Gateway AI Edge Gateway IoT Router | Compact Router |
| --- | --- |
| ![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0908-04.webp) | ![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0908-04-01.webp) |

You can delete the registered registration code by clicking "Settings" without entering the registration code.

  Confirm the information entered and click "Setup".

![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0908-05-1024x424.webp)

The remote.it configuration will be changed.