---
title: VMS
description: "**NOTE** - The VMS described in this pag…"
url: "https://manual.amnimo.com/docs/service-configuration-gui/vms/"
updated: "2025-10-03"
category: GUI（FW v3.2.0） / サービス設定（GUI）
---

# VMS

**NOTE**

- The VMS described in this page refers to amnimo VMS.
- IoT routers (amnimo R series) and compact routers (amnimo C series) do not have this feature.

This section describes the operation of the "VMS" screen.
In this section, you will configure the settings for using amnimo VMS.

Click \[Service Settings\] > \[VMS\] on the side menu to open the "VMS" screen.

![](https://manual.amnimo.com/wp-content/uploads/2025/07/GU0905-01-1024x310.png)

## Display VMS settings

The "VMS" screen displays the current VMS settings.

![](https://manual.amnimo.com/wp-content/uploads/2025/07/GU0905-02-1-1024x306.png)

## Change VMS settings

Enables/disables VMS settings.

  **Click the toggle to Enable/Disable and click Next.**

![](https://manual.amnimo.com/wp-content/uploads/2025/07/GU0905-03-1024x300.png)

  **Confirm the information entered and click "Setup".**

![](https://manual.amnimo.com/wp-content/uploads/2025/07/GU0905-04-1024x377.png)

If VMS is enabled while Nx Witness is enabled, click on "Configure" when the following message appears
![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0905-04-01.webp)

The VMS settings are changed.

  Confirm the contents and click the \[ Close \] button.

![](https://manual.amnimo.com/wp-content/uploads/2025/09/GU0905-05.webp)