---
title: GUI
description: This section describes the operation of …
url: "https://manual.amnimo.com/docs/system-configuration-gui/gui/"
updated: "2025-12-04"
category: GUI（FW v3.2.0） / システム設定（GUI）
---

# GUI

This section describes the operation of the "GUI Setup" screen.
Here you can configure GUI settings.

Click \[System Settings\] > \[GUI\] on the side menu to open the "GUI Settings" screen.

![](https://manual.amnimo.com/wp-content/uploads/2025/10/GU0806-01-1024x381.webp)

## GUI Settings

  Set the following items (1) to (2) for basic information on GUI settings and click Next.

(1) Select "HTTP" or "HTTPS" as the protocol.
Enter the port number.

 **NOTE**

- The port number can be set in the range of 1 to 65535.
- The standard port 80 for HTTP and port 443 for HTTPS are used.
- Note that if the port number is changed, the client must specify that port number to connect.

![](https://manual.amnimo.com/wp-content/uploads/2025/10/GU0806-02-1024x351.webp)

  Confirm the information entered and click "Setup".

![](https://manual.amnimo.com/wp-content/uploads/2025/10/GU0806-03-1024x413.webp)

When the GUI setup is complete, the following dialog box appears.

![](https://manual.amnimo.com/wp-content/uploads/2025/10/GU0806-03-01.png)

You will then be taken to the sign-in screen.

  If the protocol is set to "HTTPS", you may be taken to the following screen, click on the "Advanced" setting.

![](https://manual.amnimo.com/wp-content/uploads/2025/10/GU0806-04-1024x492.webp)

  ［Click Proceed to 192.168.0.254 (not secure).

![](https://manual.amnimo.com/wp-content/uploads/2025/10/GU0806-05-1024x671.webp)

You will be redirected to the sign-in screen.

![](https://manual.amnimo.com/wp-content/uploads/2025/10/GU0806-06-1024x576.webp)