---
title: Connecting to a network camera
description: "Connect the network camera to the AI Edge Gateway with a LAN cable as shown in the figure below. **NOTE** - Refer to your camera's manual for information on configuring your network camera. - Depending on your network environment and…"
url: "https://manual.amnimo.com/en/docs/connecting-to-a-network-camera-en-2/connecting-to-a-network-camera-2/"
updated: "2025-03-04"
category: "AG-SG / Connecting to a network camera"
---

# Connecting to a network camera

Connect the network camera to the AI Edge Gateway with a LAN cable as shown in the figure below.

 **NOTE**

- Refer to your camera's manual for information on configuring your network camera.
- Depending on your network environment and security settings, the camera may not be recognized. In this case, please check your VPN environment and PC security settings.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-235.png)

 **NOTE**

- If the camera supports PoE, the AI Edge Gateway's Power of Ethernet (PoE) functionality can supply power to the camera.
- When using PoE, the PoE specifications are as follows
  - Total power used by LAN 0-3 is limited to 40W
  - Maximum power used in one port is limited to 25W
- When using PoE, a LAN cable of CAT 5e (Category 5e) or higher is required.
- For information on PoE configuration, please refer to the following manuals
  [GUI User's Manual](https://amnimo.com/manual/edge_gw/gui/ja/gui_users_manual.pdf)