---
title: Connecting to a network camera
description: "Connect the network camera to the Edge Gateway with a LAN cable as shown in the figure below. **NOTE** - Refer to your camera's manual for information on configuring your network camera. - Depending on your network environment and security…"
url: "https://manual.amnimo.com/en/docs/connecting-to-a-network-camera-en/connecting-to-a-network-camera/"
updated: "2025-12-03"
category: "AG-SG / Connecting to a network camera"
---

# Connecting to a network camera

Connect the network camera to the Edge Gateway with a LAN cable as shown in the figure below.

 **NOTE**

- Refer to your camera's manual for information on configuring your network camera.
- Depending on your network environment and security settings, the camera may not be recognized. In this case, please check your VPN environment and PC security settings.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-98.png)

 **NOTE**

- If the camera supports PoE, it can be powered by the PoE (Power of Ethernet) function of the Edge Gateway.
- When using PoE, the PoE specifications are as follows
  ・Total power used by LAN 0-3 is limited to 40W
  ・Maximum power used by a single port is limited to 25W
- When using PoE, a LAN cable of CAT 5e (Category 5e) or higher is required.
- Please refer to the following manual for PoE settings.
  ⇒ GUI User's Manual ["PoE](/?doc_category=poe)