---
title: Set the time (FW v3.1.1 or earlier)
description: "Set the device's time zone and time. **NOTE** This manual describes an example of synchronizing the time with a PC. For time settings, we recommend using NTP settings to synchronize the time, but manual entry is also possible. For details,…"
url: "https://manual.amnimo.com/en/docs/step-3-configure-the-ai-edge-gateway-en/set-the-time-2/"
updated: "2026-02-03"
category: "AX-SG / Step 3 Configure the AI Edge Gateway"
---

# Set the time (FW v3.1.1 or earlier)

Set the device's time zone and time.

 **NOTE**

This manual describes an example of synchronizing the time with a PC.
For time settings, we recommend using NTP settings to synchronize the time, but manual entry is also possible.

For details, please refer to the following
⇒ GUI User's Manual [, "Setting the Time".](/?doc_category=時刻を設定する)

### Set the time zone

  Click \[Advanced Settings/Controls\] - \[Time Zone Settings\] in the side menu.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-66.png)

The "Time Zone Settings" screen will appear.

  Set the time zone.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/401-1024x437.png)

❶ Select "Region".

❷ Select "Place Name".

❸ Click \[Settings\].

The time zone is set.

### Set the time

  Click \[Advanced Settings/Controls\] - \[Time Settings\] in the side menu.

The "Time Setting" screen appears.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-68.png)

  On the "Time Settings" screen, click "NTP Settings.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-69.png)

  Slide the toggle to enable.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-70.png)

  Change the settings. **NOTE**

Regarding NTP servers, Amnimo recommends Google Public NTP (time.google.com) and NICT public NTP service (ntp.nict.jp). Please see below for terms of use and precautions for each service.

- Google Public [NTP:](https://developers.google.com/terms/) https://developers.google.com/terms/
- NICT Public NTP Service: [https://jjy.nict.go.jp/tsp/PubNtp/qa.html](https://jjy.nict.go.jp/tsp/PubNtp/qa.html)

If this procedure is used, NTP time synchronization will be performed at the following intervals (these values can be changed from the CLI).

- Immediately after network connection starts: 64s interval
- After that, time synchronization is continuously performed with gradually increasing intervals
- Final, periodic synchronization interval: 1024s

![](https://manual.amnimo.com/wp-content/uploads/2024/07/403-1024x456.png)

❶ Select the interface on which Internet communication takes place for NTP synchronization.

For mobile communication, select "ecm0", "rmnet_data0", etc.

❷ The URL of the server to be synchronized.

❸ Specifies the port number. If there are no problems with the default value, there is no need to change it.

  ［Click Settings.

The time setting is saved.

![](https://manual.amnimo.com/wp-content/uploads/2024/07/image-72.png)