The IoT Router (indoor version) starts automatically when the power supply is connected. On the other hand, the IoT Router (outdoor version) starts up when the power supply is connected and the power switch is turned ON.
Power switch (IoT router outdoor version) #
Set the DIP switch to “Linux boot mode” and connect the power supply as shown below.
DIP switch settings (Linux boot mode) #
WARNING
Do not perform the following operations during the startup sequence to avoid malfunction.
- Power ON/OFF
- Switching DIP switches
The status of the IoT router can be checked via the LEDs on the unit and the CONSOLE port.
ALERT
About the initial password for the bootloader
Please contact our customer support for the initial password when starting the IoT router in U-Boot mode.
Contact : Amnimo Customer Support
E-mail : support@amnimo.com
URL : https://support.amnimo.com
*Please be sure to change this password.
