Insert the SIM card to be used into the back of the AI Edge Gateway.
NOTE
Insert the SIM card so that its contacts are on the bottom side.
Connect the LAN0 port of the AI Edge Gateway to the PC using a LAN cable.
Set the configuration DIP switch on the front of the AI Edge Gateway to Linux boot mode.
Explanation of DIP switch icons
| DIP switch | Description. |
|---|---|
 | ON state |
 | OFF state |
NOTE
The No. 4 DIP switch can be ON or OFF. It is not referenced by the boot loader (used only on the application side).
Connect the AC adapter to the AI Edge Gateway.
Power is automatically turned on and the AI Edge Gateway is activated.
AIエッジゲートウェイ（屋内版）をシャットダウンするには
You can shut down the system in one of the following ways During shutdown, the LED PWR will flash; when the LED PWR turns red, the shutdown is complete.
- Turn off the power by pressing down the PUSH switch on the main unit with a thin, pointed tip for at least 3 seconds during startup.
- Shut down with the following command
- Refer to the Edge Gateway Series CLI User’s Manual for command usage.
admin@amnimo:~$ sudo systemctl poweroff
[sudo] password for admin: ← Enter root password and Enter
Stopping Docomo of user admin.
Stopping Unpack initramfs on shutdown…
(Omitted)
Starting Power-Off
NOTICE: You can turn off the power.
LED indication during shutdown process
| (data) item | PWR | ANT | MOB | ST1 | ST2 | ST3 | remarks |
|---|---|---|---|---|---|---|---|
| shutdown process in progress |  | 500ms interval | |||||
| power disconnected (state) |  |
自動起動機能に関する注意事項
- Because AI edge gateways are intended to operate 24 hours a day, they have the ability to automatically recover from a shutdown in the event of a failure.
- Therefore, if the AI Edge Gateway is shut down in the manner described in this section, but power is still supplied by the power connector, it will restart.
- If you wish to put the AI Edge Gateway into a power-off state, shut it down and wait until the LEDs are in a power-off ready state (power LED lit red) before pulling the power plug.
