Table of Contents
Compact routers can be rebooted by command operation.
There are two types of reboots: software reboot, which stops the system, and hardware reboot, which does not stop the system.
- For more information on the Command Line Interface (CLI) for using commands, see "Chapter 1 CLI Basics" in the amnimo gateway series CLI User's Manual.
- To reboot using the Compact Router's dedicated CLI, see "2.1 Rebooting the Product" in the " amnimo Gateway Series CLI User's Manual ".
NOTE
To reboot the compact router, you must enter administrator mode.
Software reboot #
Software reboot after system shutdown.
Execution example #
An example of command execution is shown below.
amnimo$ enable ← 管理者モードに移行
password: ← パスワード入力
amnimo# reboot type soft
Are you sure you want to restart? (y/n):y ←「y」キーに続けてEnterを入力NOTE
- To reboot the compact router, you must enter administrator mode.
- To cancel execution of the command, type the "n" key followed by Enter.
Hardware reboot #
Without shutting down the system, power off the hardware and reboot.
Execution example #
An example of command execution is shown below.
amnimo$ enable ← 管理者モードに移行
password: ← パスワード入力
amnimo# reboot type hard
Are you sure you want to restart? (y/n):y ←「y」キーに続けてEnterを入力NOTE
- To reboot the compact router, you must enter administrator mode.
- To cancel execution of the command, type the "n" key followed by Enter.
