Insert the SIM card to be used in the Edge Gateway and connect the PC to the LAN0 port of the Edge Gateway with a LAN cable as shown in the figure below.
NOTE
Insert the SIM card so that its contacts are at the back.
Set the configuration DIP switch on the top of the edge gateway to Linux boot mode.
| DIP switch | Description. |
|---|---|
 | ON state |
 | OFF state |
NOTE
The No. 4 DIP switch can be ON or OFF. It is not referenced by the boot loader (used only on the application side).
Connect the AC power cable to the edge gateway.
Turn on the power switch to activate the edge gateway.
- For details, please refer to the ” Outdoor Type Installation Guide ” included with the product.
エッジゲートウェイ（屋外版）をシャットダウンするには
You can shut down the system in one of the following ways During shutdown, the LED PWR will flash; when the LED PWR turns red, the shutdown is complete.
- Turn off the power by pressing down the PUSH switch on the main unit with a thin, pointed tip for at least 3 seconds during startup.
- Shut down with the following command
- Refer to the Edge Gateway Series CLI User’s Manual for command usage.
admin@amnimo:~$ sudo systemctl poweroff
[sudo] password for admin: ← Enter root password and Enter
Stopping Docomo of user admin.
Stopping Unpack initramfs on shutdown…
(Omitted)
Starting Power-Off
NOTICE: You can turn off the power.
LED indication during shutdown process
| (data) item | PWR | ANT | MOB | ST1 | ST2 | ST3 | remarks |
|---|---|---|---|---|---|---|---|
| shutdown process in progress |  | 500ms interval | |||||
| power disconnected (state) |  |
自動起動機能に関する注意事項
- Since the Edge Gateway is intended to operate 24 hours a day, it has the ability to automatically recover in the event of a shutdown, such as in the event of a failure.
- Therefore, if the Edge Gateway is shut down in the manner described in this section, but power is still supplied by the power connector, it will restart.
- If you wish to put the Edge Gateway in a power-off state, shut it down and wait until the LEDs are in a power-off ready state (power LED lit red) before pulling the power plug.
