Table of Contents
AI Edge Gateway (indoor version) #
The AI Edge Gateway (indoor version) starts automatically when the power supply is connected.
AI Edge Gateway (outdoor version) #
The AI Edge Gateway (outdoor version) is activated when the power supply is connected and the power switch is turned ON.
power switch
DIP switch settings (Linux boot mode) #
Set the DIP switch to “Linux boot mode” and connect the power supply as shown below.
ALERT
Do not perform the following operations during the startup sequence to avoid malfunction.
- Power ON/OFF
- Removing and inserting SD cards and other storage media
- Switching DIP switches
The status of the AI Edge Gateway can be checked via LEDs on the main unit and the CONSOLE port.
ALERT
About the initial password for the bootloader
Please contact our customer support for the initial password when starting AI Edge Gateway in U-Boot mode.
Contact : Amnimo Customer Support
E-mail : support@amnimo.com
URL : https://support.amnimo.com
Be sure to change this password.
