About factory default settings

This section describes the factory default settings for the AI Edge Gateway.

network #

wan0: dhcpv4
lan0:
lan1:
lan2:
lan3:
br0: 192.168.0.254/24
-lan0/lan1/lan2/lan3

Initial Account #

• ID: admin
• PW: No setting (set at first login)

initial host name #

• amnimo

Server Settings #

server	setting (of a computer or file, etc.)
SSH Server	invalid
DHCP Server	invalid
DNS Server	validity
IPsec	invalid
NTP Server	invalid
Syslog server (local storage)	validity
Syslog server (forwarding)	invalid
NxWtiness Server	validity
Device Management System Server	validity
GUI (HTTP server)	Valid*.
remote.it	invalid

*If your gateway version is V1.1.2 or earlier, the default DNS server setting is disabled and there is no GUI function. When updating from V1.1.2 to V1.2.1 or later, if DNS is not configured, it is disabled. GUI is disabled.
Note that the version can be checked using the CLI and GUI functions. For details, please refer to the following.
⇒CLI User’s Manual “2.4.1 Displaying Firmware Version”
⇒GUI User’s Manual “Checking Device Information

PoE Configuration #

All ports are configured as follows

• Power supply: Enabled
• Startup delay time: 0 sec.
• Current limit: auto

packet filtering configuration #

index number	Port No.	protocol	Description.	From / To	setting (of a computer or file, etc.)	policy
100	137, 138	udp	NetBIOS Name Service NetBIOS Datagram Service	destination (of transmission)	transfer	drop
110	137, 138	udp	NetBIOS Name Service NetBIOS Datagram Service	sender	transfer	drop
120	137	tcp	NetBIOS Name Service	destination (of transmission)	transfer	drop
130	137	tcp	NetBIOS Name Service	sender	transfer	drop
140	139	tcp	NetBIOS Session Service	destination (of transmission)	transfer	drop
150	139	tcp	NetBIOS Session Service	sender	transfer	drop
160	445	tcp	Direct Hosting of SMB	destination (of transmission)	transfer	drop
170	445	tcp	Direct Hosting of SMB	sender	transfer	drop