View Categories

Name and role of each part of the sensor connection gateway

Table of Contents

This section describes the basic configuration of the sensor connection gateway main unit.

Sensor Connection Gateway #

This section describes the basic configuration of the sensor connection gateway main unit.

facade

The configuration of the front panel (with the lid of the SD card section open) is shown below.

No.nameDescription.
subantennaConnect antenna for 3G/4G line, SMA-J type.
USB portOperates as a USB 2.0 host.
LED IndicatorPWR: Displays the power supply status.
ANT: Displays the antenna status.
MOB: Shows the line connection status of the communication module.
ST: Specific status is displayed in combination with other indicators.
PUSH switchUsed to shut down the sensor-connected gateway or to restore it to factory settings.
(in Japanese) ❺DIP switches for configurationSets the startup mode of the sensor connection gateway.
(in Japanese) ❻CONSOLE PortUsed to configure the sensor connection gateway.
SIM card slot 0,
SIM card slot 1
Two SIM cards can be inserted in the SIM card slot. The priority level changes depending on the setting. By default, SIM 0 is used.
(in Japanese) ❽main antennaConnect antenna for 3G/4G line, SMA-J type.

back

The rear configuration (with the SIM card section lid open) is shown below.

No.nameDescription.
RS485 portNon-isolated type serial communication pins for connection to external devices.
D OUTIsolated type digital output terminal for connection to external devices.
D INIsolated type digital input terminal for connection to external devices.
A INIsolated type analog input terminal for connection to external devices.
The sixth and seventh pins from the left are frame grounds.
(in Japanese) ❺LAN0 and LAN1 ports (2-port switch)Standard Ethernet port with Gigabit Ethernet support, PoE (IEEE802.3at) compliant and PoE power supply.
(in Japanese) ❻PWRConnect the supplied dedicated power supply AC adapter.

three-sided view

A three-view diagram is shown below.

Scroll to Top