The Edge Gateway (indoor version) starts automatically when the power supply is connected. On the other hand, Edge Gateway (outdoor version) starts up when the power supply is connected and the power switch is turned ON.
Power switch (Edge gateway outdoor version) #
Set the DIP switch to “Linux boot mode” and connect the power supply as shown below.
DIP switch settings (Linux boot mode) #
WARNING
Do not perform the following operations during the startup sequence to avoid malfunction.
- Power ON/OFF
- Removing and inserting SD cards and other storage media
- Switching DIP switches
The status of the edge gateway can be checked via LEDs on the main unit and the CONSOLE port.
ALERT
About the initial password for the bootloader
- Please contact our customer support for the initial password when starting AI Edge Gateway in U-Boot mode.
Contact : Amnimo Customer Support
E-mail : support@amnimo.com
URL : https://support.amnimo.com
- Be sure to change this password.
