From the gateway configuration, the following camera power operations (PoE) can be performed
- Start/Stop/Reset PoE power supply
- Start/Stop/Reset USB power supply
Indicates the name of each port of the device.
Indicates the status of each port.
Up : Link is up.
Down : Link is down
Unknown ：State cannot be obtained
Indicates whether power is being supplied.
ON : Power is supplied.
OFF : Power is not supplied.
Unknown : When the status cannot be obtained
ETH0 port of AG series is displayed as “unknown” because it does not provide PoE power.
You can enter a description of the device connected to each port.
You can stop and start the power supply for each port.
Reset ：Stops supplying power and then starts supplying power after a specified time.
ON: Starts supplying power OFF: Stops supplying power
PoE power supply ON/OFF reset #
It is also possible to perform an action on another port while the power supply function of the other port is being reset/turned on/off.
Reset (*): Disables the power feed function for a specified time (reset time) and automatically enables it after the specified time elapses.
ON: Enables the power feed function.
OFF: Disables the power feed function.
LAN port: 1 second to 60 minutes (default setting: 1 minute)
USB port: 1 second to 60 minutes (default setting: 10 seconds)
For reset, specify a wait time and click Reset.
