View Categories

remote.it

This section describes the operation of the "remote.it" screen.
Here you can configure settings for using remote.it.

Click [Service Settings] > [remote.it] on the side menu to open the "remote.it Settings" screen.

View remote.it settings #

The "remote.it settings" screen displays the current status of the remote.it settings.

Change remote.it settings #

Enables/disables remote.it settings.
Below are the steps for activation.

Click the toggle.

Enabling "remote.it settings" will allow you to use remote.it to control devices.

For Edge Gateway / AI Edge Gateway / IoT Router, click Settings.
For compact routers, perform the following precautionary tasks
NOTE

For compact routers (amnimo C series), the registration code must be registered.
Registration codes must be obtained separately from the remote.it web page.

Edge Gateway
AI Edge Gateway
IoT Router
Compact Router

You can delete the registered registration code by clicking "Settings" without entering the registration code.

Confirm the information entered and click "Setup".

The remote.it configuration will be changed.

Scroll to Top